Small 12 volt electric horn with black body. Approximately 100mm diameter and 55mm deep. Single hole fixing bracket with 8.3mm hole. Two 6.3mm slade/Lucar type connections
Parts
High quality 12V horn made by Klaxon in France. Gloss black finish. KW9 model (CH5070105, 722367). 92mm body diameter, 67mm total depth including front central spigot and rear mounting bolt....
Large 12-volt electric horn with chrome cover fitted with chrome on brass 'Toby' medallion in the centre and stainless steel domed nuts around the edge of the cover, in the style of the 'Altette'...
Small 12-volt electric horn with chrome grill and chrome on brass TOBY badge to centre. Stainless steel domed nuts around the rim in the style of the 'Altette' horn. Approximately 100mm in...
New made part (not refurbished). Bolt hole centres 5" apart on flange.
12 volt non ballasted sports coil, offered with push in HT wire connection only. Gives a stronger spark than the standard specification coil. Lucas part number DLB105. 55MM Dia. Push in HT lead....
Round base Note the spark firing order 1-2-4-3 (1 is front cylinder)
Hydraulic oil pressure warning light switch, tapered 1/8 NPT thread with lucar terminal.
Dynamo / generator 12 volt. New made part (not refurbished)
12 volt 22A voltage regulator/control box with Lucar push-on terminals. Size approximately 85mm x 80mm x 95mm tall. black. 2 bobbin type. Equivalent to Lucas Part Numbers NCB101 and RB106....
Starter motor - newly manufactured part, not refurbished. Mounting bolt hole centres 4.5" apart on flange, starter comes with a two bolt fixing flange which suits other models.
Electrical temperature sender sensor unit, lucar terminal. thread approx 3/8" (10mm) outside. used 105E engine. Colour coded Blue.
Electrical temperature sender sensor unit, lucar terminal. thread approx 5/8 (15.6mm) outside. used on Upright, 100E and some 105E engines. Colour coded Red.
Coil mounting bracket, two bolt fixing with elongated slots measuring 78mm max, 42mm min, will hold coil with a maximum diameter of 56mm.
Distributor low tension lead assembly with points wire and Lucar wiring connector. Replaces Fod part number 105E-12049-A. Also equivalent to Lucas part number 54413549 for 22D6 and 22D4...
Solderless battery terminal, round post, state whether positive or negative required.
negative
negative
Solderless battery terminal, round post, state whether positive or negative required.
Positive
Positive
solder type end fixing terminal for usual 160amp battery lead/cable, fixing hole 8mm, cable inlet 8mm.
Contact set / ignition points set for late distributors on 105E model 1966 to 1968. Lucas type DSB753. As part reference Ford part 681F-12107-AA, Motorcraft EDP1, Ci ref CS110. Also application...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Black rubber grommets WITH hole. For approximately 1.5mm panel thickness. Packet size varies according to grommet size - to suit panel hole of:
6.5mm - pack of 100 pieces
8mm - pack of 100...
6.5mm - pack of 100 pieces
8mm - pack of 100...
Assortment pack of grommets WITH hole. 90 pieces in a range of sizes for 6.5mm through to 25mm diameter panel holes. For metal panel thicknesses up to 1/6mm.
Flasher unit - three Lucar terminals marked L, P & X. L goes to live, P goes to warning light, X goes to indicators.
Flasher unit with three Lucar spade terminals and end mount tag. 21 Watt x...
Flasher unit with three Lucar spade terminals and end mount tag. 21 Watt x...
Rotor arm equivalent to Lucas part number DSB752C. For late distributors on 105E model 1966 to 1968. Ford part number C6AH-12200. Motorcraft EDR3, CI reference R64. Other applications - Ford...
Condenser for late distributors on 105E model 1966 to 1968. Autolite type, as part reference Ford part C6AH-12300-A. Motorcraft EDC2, CI ref CON75, also application Ford Fiesta 1976 onward, Escort...
Roof mounted radio aerial supplied with 2 metres of cable. 4.5mm mounting bolt, 530mm long, 890mm extended, spring base.
Universal battery clamp bracket to keep the battery well secured. With a long angled bar that pulls against the side of the battery and screw thread adjuster rods for fitting the end to holes in...
Large and noisy 12 volt electric horn. Approximately 150mm diameter x 90mm deep (front to back). Chrome grill, mounting arm supplied.
Small 12 volt electric horn with chrome grill. Approximately 100mm diameter and 55mm deep. Single hole fixing bracket
Two, three and four brush dynamo and starter brush sets.
100E & 105E
100E & 105E
Two, three and four brush dynamo and starter brush sets.
8/10hp 1940 onwards
8/10hp 1940 onwards
12 volt 22A Voltage regulator/control box with screw terminals. Size approximately 85mm x 80mm x 95mm tall. Black. 2 bobbin type. Equivalent to Lucas Part Numbers RB106 and NCB100. Mechanical unit...
Distributor cap spring clip, holds distributor cap onto the distributor body, fits distributors 1959-62, with round cap . overall length 78mm, 8mm wide.
We offer replacement keys, cut for door and ignition switch. These are cut to number only, 2 keys are supplied. Supply is restricted to the following key series - key sequence numbers MRN1 through...
Dynamo drive end (front) sealed bearing, dimensions o/d 35mm, i/d 15mm, 11mm wide. Fits all models with a Dynamo fitted
distributor contact point set - as Lucas 407050, which has very wide application.
one piece each 12162, 12153 & 12160 shown on diagrams.
new re-manufactured part
one piece each 12162, 12153 & 12160 shown on diagrams.
new re-manufactured part
Lucas reference 400051 or 405468 - fitted to wide range of vehicles through to approx 1973.
Prices shown include VAT @ 20% where applicable
